Hi everyone!
I'd like to use PWM outputs from my Edison kit for Arduino to provide PWM inputs to my Solo drone. I want these PWM inputs to control the motors of Solo. I have the accessory breakout board found here 3DR Solo Accessory Breakout Board
Can I access the PWM ports on Solo to do this? If so, which ports? Is it the IO-PWM6, 7, and 8? Or should I use the ch6, 7, and 8? I've been searching everywhere for an answer to this, but I'm not finding any definitive information for doing this on Solo.
Thanks!
I'd like to use PWM outputs from my Edison kit for Arduino to provide PWM inputs to my Solo drone. I want these PWM inputs to control the motors of Solo. I have the accessory breakout board found here 3DR Solo Accessory Breakout Board
Can I access the PWM ports on Solo to do this? If so, which ports? Is it the IO-PWM6, 7, and 8? Or should I use the ch6, 7, and 8? I've been searching everywhere for an answer to this, but I'm not finding any definitive information for doing this on Solo.
Thanks!