So I tried out 4K for the first time on the Solo, and noticed that it is showing the leg to the left of the video (will never go away). Has anyone else got this their Solo leg in the shot while shooting 4K Wide. If so any ideas to minimize this issue, or get rid of it completely?
I was thinking about printing some "new" legs out on the 3D printer, to set them just a bit farther apart, as well as make them a bit longer. As the Solo legs are way too short with the 3 axis Gimbal installed. GoPro gets covered in the grass on launch, which is a problem when there is a little bit of moisture on the ground, as the water will get on the lens easily. Most importantly just for the fact the legs are too short.
I was thinking about printing some "new" legs out on the 3D printer, to set them just a bit farther apart, as well as make them a bit longer. As the Solo legs are way too short with the 3 axis Gimbal installed. GoPro gets covered in the grass on launch, which is a problem when there is a little bit of moisture on the ground, as the water will get on the lens easily. Most importantly just for the fact the legs are too short.