SO yesterday I had the closest call from going into the lake nearby. I've recently started using the Pano smartshot. Learning the best settings for overlap and best stitching software. The shot finished and I was positioning for another shot and I noticed the screen freeze. So I was bringing it home and I got to a point about 5 ft or so above ground, and it just dropped. No Power.
I came home did some searching, hard resets, inspected, took it outside for a test flight. It was at about 20ft up and I switched from loiter to stabilize, and it dropped from the sky, bounced and flipped. It is now grounded. (OK I think this was just dumba** pilot error, but does not explain initial fall from sky)
I've downloaded and installed Mission planner but can't figure out how to use the diagnostic aspect of it to see if I have a power issue of some sort, GoPro interference, or a bad pod. If anyone could maybe give some pointers. It would be appreciated.
I've downloaded and installed Mission planner but can't figure out how to use the diagnostic aspect of it to see if I have a power issue of some sort, GoPro interference, or a bad pod. If anyone could maybe give some pointers. It would be appreciated.
Last edited: