Hello Everyone,
I recently acquired two Solo airframes, one darn near new and on that shows signs of a crash.
I’m new to the Solo platform but am very excited to join the community. I’ve known about the Solo for many years but has always been either difficult to find or prohibitively expensive.
My hope is to utilize these airframes as a building block as I work my way through an unmanned course at my local university and obtain a Part 107 license.
I like to tinker and seeing the support behind this airframe is amazing! Starting out, I would love to hear anything from the group about getting and keeping these airframes flying. Hopefully I might eventually give back to the community utilizing my skillset in additive manufacturing and knowledge in CAD environments.
Looking forward to meeting you all and safe flying!
-CM
I recently acquired two Solo airframes, one darn near new and on that shows signs of a crash.
I’m new to the Solo platform but am very excited to join the community. I’ve known about the Solo for many years but has always been either difficult to find or prohibitively expensive.
My hope is to utilize these airframes as a building block as I work my way through an unmanned course at my local university and obtain a Part 107 license.
I like to tinker and seeing the support behind this airframe is amazing! Starting out, I would love to hear anything from the group about getting and keeping these airframes flying. Hopefully I might eventually give back to the community utilizing my skillset in additive manufacturing and knowledge in CAD environments.
Looking forward to meeting you all and safe flying!
-CM
