Solex Update 1.6.4

[IrishmanPDX]

He's probably busy making even more changes to Solex (we hope!). Damn fine program!

 

[psybersapien]

FWIW, I updated to v1.6.7 and noticed the connect button with the options UDP and USB. I was connected to the solo wifi and wanted to connect via wifi (not UDP or USB). I hit the connect button once with no effect and when I hit it again, the voice feedback asked me to hit the button again to connect to wifi. Once I did that, I connected to the vehicle and was off flying with a boat load of telemetry at my finger tips.

Awesome app. Keep up the good work!

 

[XevetS]

I was connected to the solo wifi and wanted to connect via wifi (not UDP or USB).

UDP is WiFi, so you were connected to UDP/WiFi

 

[psybersapien]

@XevetS Good to know. Thanks! Now I know UDP == WiFi in this case.

 

[chascaudill]

I had the same issue today. I was testing my batteries (6) and after the first two batteries I got the video not supported screen after I always let the parameters load and the bird flew correct and my go pro would record I just could not see the feed. Any other ideas?

 

[IrishmanPDX]

Check the screen resolution on your device. Solex can sometimes act a bit iffy if you're using too high a resolution (it may or may not work). Make sure your screen is either using HD (1280*720) or FHD (1920*1080). Anything higher than that (WQHD 2560x1440) and you may experience issues.