I recently upgraded my wireless cards in my Solo and controller. I followed the instructions of a few tutorials I found online and used this wireless card: MikroTik 802.11b/g/n 2GHz 800mW MiniPCI-Express Wireless Card
After putting everything back together, I started up the Solo but it wasn't connecting to any satellites. One step I wasn't sure if I followed correctly was reattaching the transmitter and receiver to the wireless card since it wasn't clear in the tutorial or on the card. I'm thinking they are either both correct or both incorrect, but not just one. I went back and swapped the connections on both wireless cards, but still get no satellite connections.
Everything else seems to function correctly. Controller and drone are connecting, GoPro is streaming, etc.
I have two questions I'm hoping to solve:
1) Any ideas on what would be causing Solo to not connect to any satellites?
2) Is there any way to confirm/test if the transmitter and receiver are hooked up correctly? The stock cards used J2 and J3 connections, while the card I replaced used 200 and 201 labeled connections.
After putting everything back together, I started up the Solo but it wasn't connecting to any satellites. One step I wasn't sure if I followed correctly was reattaching the transmitter and receiver to the wireless card since it wasn't clear in the tutorial or on the card. I'm thinking they are either both correct or both incorrect, but not just one. I went back and swapped the connections on both wireless cards, but still get no satellite connections.
Everything else seems to function correctly. Controller and drone are connecting, GoPro is streaming, etc.
I have two questions I'm hoping to solve:
1) Any ideas on what would be causing Solo to not connect to any satellites?
2) Is there any way to confirm/test if the transmitter and receiver are hooked up correctly? The stock cards used J2 and J3 connections, while the card I replaced used 200 and 201 labeled connections.