Hi,
Yesterday i went to an open field to take some shoots of a land that i want to sell.
Nearby there are few small houses with only electric service
I have the controller with full battery and Alfa antennas and the solo whit 2 full batteries and de GoPro Hero 4 Black (5.0) also with full battery installed on the gimbal
I took off the first time and raise the solo about 30m and lost all the signal, solo return to home
I change the antenas to the stock ones and try again
I took off raise the solo about 30m and get only 2 bars of signal, then i have full signal and at that point i start to make the shots (1 orbit)
The longest shot was 150m from home and i have only 1 signal bar, after i think 25min (with the 2 batteries) i finish the shots but all the time i just have 2 or 3 signal bars, only when the solo was landing i have full signal
What can i check to verify if it was my solo or controller, or was the zone?
Yesterday i went to an open field to take some shoots of a land that i want to sell.
Nearby there are few small houses with only electric service
I have the controller with full battery and Alfa antennas and the solo whit 2 full batteries and de GoPro Hero 4 Black (5.0) also with full battery installed on the gimbal
I took off the first time and raise the solo about 30m and lost all the signal, solo return to home
I change the antenas to the stock ones and try again
I took off raise the solo about 30m and get only 2 bars of signal, then i have full signal and at that point i start to make the shots (1 orbit)
The longest shot was 150m from home and i have only 1 signal bar, after i think 25min (with the 2 batteries) i finish the shots but all the time i just have 2 or 3 signal bars, only when the solo was landing i have full signal
What can i check to verify if it was my solo or controller, or was the zone?