KDE 2315XF 885kv physical measurement

[RolandS888]

Just did a test it use between 19.5A to 21.5A just hovering about 6 feets high
Motors ares running hot, takes around 14 mins to reach 15% started at 96%

34LAK-USA How was the performance verses stock?
So So ... the triples drain more energy that's a fact
but im not a good pilot to push it a gets the benefits of triples blade config
im shure you gain more response and faster accelerations more payload

Cudo to you SPP neat detailed infos

@ProStock go back to stock props, the 3 bladers are less efficient.
Im not surprised to see a current increase with those props.

 

[ProStock]

@Rolland Today i will remove the motor adapters for the tri blades and give a shot to the stock props and the APC 10X4.5 props
Q: in the log is there a place i can get the infos for the amps and watts eachs motors ares using ?

@SPP i just recived my battery spot welder
And i have here somes cells left available out of my pack of 150 pcs for my E-bike new battery
Model:LG INR18650HG2
Chemistry: INR
Max. continuous discharge current: 20A
Nominal capacity: 3000 mAh
Nominal voltage: 3.6 V
Discharge end voltage: 2.5 V
Charging voltage: 4.20 +/- 0.05 V
Standard charging current: 1500 mA
65mm long 18mm diameter 47gr

Do you think it's possible to build a Solo battery out of these cells ?

 

[SPP]

Pro,
Wait for 3rd party to make a more advance battery, when the technology allows.

 

[SPP]

Pro,
How is your Solo doing with the KDE motor ?
Me just got my 2nd Solo and considering to swap to KDE motors, since I already got the KDE-s.
Efficiency wise as per my dynometer test its not too good, but who cares experimenting is the fun part.

thanks

 

[ProStock]

My KDE motors still going strong actuly theys drain less power after somes flight about 17.5 A before it was around 19 A
Go for it

 

[SPP]

Okey dokey...will do when I have spare time...thanks Pro

 

[tonyb]

ProStock and SPP,

Since you had the KDE motors for a while, what is the verdict? Would you still recommend them?

 

[ProStock]

Well my KDE motors runs great still but this products as been discontinued
you can still buy thems at KDE Website but theys asking $61 eachs + SH
you better go with T-Motor 2216-12 800kV OR
SUNNYSKY X2216 880

 

[SPP]

tony, me never got to install the KDE yet
been too busy

 

[tonyb]

SPP and ProStock, thank you both for your responses.

I used SunnySky x2212 in the past on my flamewheel build and had good luck with them.
The KDE looks too expensive for what they are. So I think this time around I am going to try T-Motor 2216-12 800kV for the Solo.

 

[SPP]

I did convert 1 of my Solo to T-Motor...I love it.
My dynometer test showed T-Motor is more efficient. I think in real world use it would the the true case too.
Motors Efficiency : Solo OEM vs T-Motor vs KDE