Here GPS

[Ismael Bugarin]

https://3drpilots.com/threads/olmost-there-solo-one-is-getting-the-here.10449/#post-111002

See post #8

 

[BillHally101]

https://3drpilots.com/threads/olmost-there-solo-one-is-getting-the-here.10449/#post-111002

See post #8

Thank you! I had an incling that SCK was next to the VCC but just needed to confirm it before connection.

Cheers Bill

 

[TUCAN2016]

GREAT INFO @speatuk ,
THANKS!

 

[oceanoprofondo7]

if I buy this:
mRo GPS u-Blox Neo-M8N / 3DR SOLO Upgrade (New)
is not the same?
thanks

 

[DromoCR]

Hey I got the here gps on my solo and is flashing yellow and my remote say magnetic interference please help!

 

[BillHally101]

Hey I got the here gps on my solo and is flashing yellow and my remote say magnetic interference please help!

If you connected the compass in the Here GPS unit you will need to do a compass calibration.

 

[XevetS]

Hey I got the here gps on my solo and is flashing yellow and my remote say magnetic interference please help!

make sure you change the compass orient from 38 to 0 in mission planner and write parameters then do a level calibration and compass calibration. Done

 

[DromoCR]

make sure you change the compass orient from 38 to 0 in mission planner and write parameters then do a level calibration and compass calibration. Done

Call me

 

[CumulusImaging]

After installing my new here GPS and mast, I used Mission Planner and updated to the external Compass, after saving the new setup and disconnecting, the controller keeps saying compass error and I do not see any "Power" or Link lights on the here. I am stumped, any advice why this is happening?

 

[XevetS]

Is it wired correctly? Please give us a little more info perhaps we can help..

 

[brianuc4]

After installing my new here GPS and mast,
the controller keeps saying compass error and I do not see any "
any advice why this is happening?

Get an mRo?

 

[CumulusImaging]

Is it wired correctly? Please give us a little more info perhaps we can help..

Seems to be. Using the after market cable that came with the mast I purchased

 

[XevetS]

Looks correct, I would inspect each and every connector wire for looseness, If you have no LED's on power-up you have an Issue, also what does mission planner show as far as gps and compass settings?

 

[pyrate]

and change the compass parameter to 0 from 38

 

[XevetS]

I used Mission Planner and updated to the external Compass

Pretty sure that's what he meant in this post, or "Or maybe not"?

 

[carpy]

Pretty sure that's what he meant in this post, or "Or maybe not"?

Man, I hope so.

 

[Dronzalo]

Hello how are you. I think it is a bit old but, buy a second-hand 3dr only and for now everything is fine make the cable by cutting the old one and apparently it works.
In planner mission just configure 3 values:
COMPASS_EXTERNAL: EXTERNAL
COMPASS_ORIENT: NONE
COMPASS_ORIENT2: NONE

Do you know where I can get the model to print the GPS base?

I haven't tried it yet but then I show results.