Where can I get the cable from the GPS to the Motherboard

[David McCullough]

Anyone know where I can get a new cable that goes from the GPS unit to the motherboard... I upgraded mine to a new one that required cutting and using a different plug on the GPS side. Unfortunately, it did not work so I had to re-solder the wires. Not pretty but working. I did find a Drop in from Mrobotics and it works great! It tracked I6 satellites most of the time and never less than 12. I did isolate the GPS from the chassis by using tiny rubber O-rings on each side of the board and putting the screws through them so the board was not hard mounted to the chassis..Not sure if that makes a big difference. But I do want to replace the cable with a new one just in case...

 

[Lexfor]

I've wondered this too. 3DR support told me it is called a "6-pin Adapter, Molex Clik-mate."

MRobotics has a couple that might work, but I don't know for sure.

mRo GPS adapter - Molex CLIK-Mate to DF13 6-Pins

mRo GPS adapter - Molex CLIK-Mate to JST-GH 6-Pins

Can anyone confirm that one of these will work?

 

[David McCullough]

Thanks I bet I need the Clik-Mate on both sides. I ordered the Molex CLIK-Mate to DF13 6-Pins thinking it might work but it only had 5 wires and the DF side was different.

 

[Dogman1973]

yeah it's the clik on both ends