Hoping to do a thing release mod and I have a few questions.
1. Does the +5V / GND (BEC I believe) provide enough amps to power a small tower pro sg90 micro servo? I am talking about the one somewhat under pin 23 on the mainboard.
2. Is this the same +5V that is provided to servos using the breakout board or does the breakout board have UBEC on it?
3. Am I going to need to use mission planner to setup this servo, or will the pause button work on the controller for ch7 without any changes?
Thanks in advance.
JB
1. Does the +5V / GND (BEC I believe) provide enough amps to power a small tower pro sg90 micro servo? I am talking about the one somewhat under pin 23 on the mainboard.
2. Is this the same +5V that is provided to servos using the breakout board or does the breakout board have UBEC on it?
3. Am I going to need to use mission planner to setup this servo, or will the pause button work on the controller for ch7 without any changes?
Thanks in advance.
JB
