Problems!

[Nick Wollman]

okay my first issue is some of my batteries are acting weird. Below 25 percent some start decreasing percentage very rapidly. And when I land at 10 percent or 15 percent I look at my battery lights and three of them are still lit. And the voltage is still 14.8. This doesn't seem right. That might be an issue with my telemetry with the 14.8 because I think that's a full battery. But three lights still on??

The second thing is my video feed is total crap. Freezing rolling what have you. I checked both sides of the HDMI connection. Now the whole feed is overlaid wth bright green. I can't seem to get it to work.

 

[PdxSteve]

16.8V is a full battery. The battery percentage is not linear. It depletes faster as it approaches 0. Each light on the battery represents ~12% since there are only 8 instead of 10. Also a battery that is actively being used will show a lower voltage than if it wasn't being used, so after you land the voltage should be slightly higher than just before you touched down.

 

[LAK-USA]

16.8V is a full battery. The battery percentage is not linear. It depletes faster as it approaches 0. Each light on the battery represents ~12% since there are only 8 instead of 10. Also a battery that is actively being used will show a lower voltage than if it wasn't being used, so after you land the voltage should be slightly higher than just before you touched down.

Nice job on the explanation Steve.

 

[WisdomWizard]

okay my first issue is some of my batteries are acting weird. Below 25 percent some start decreasing percentage very rapidly. And when I land at 10 percent or 15 percent I look at my battery lights and three of them are still lit. And the voltage is still 14.8. This doesn't seem right. That might be an issue with my telemetry with the 14.8 because I think that's a full battery. But three lights still on??

The second thing is my video feed is total crap. Freezing rolling what have you. I checked both sides of the HDMI connection. Now the whole feed is overlaid wth bright green. I can't seem to get it to work.

I have the same overlay of green video problems. I can barely make out anything.
First it was intermittent. Now it is constant. I even tried with the HDMI cable direct without the gimbal. The video is fine when recorded and also fine when played out of the GoPro with the HDMI cable to a TV. Let me know if you find a solution please.