Controller displays successful GPS lock and says press and hold FLY to take off , but when I hold down the fly button the motors remain motionless. They fail to spin up. When holding FLY the green bar moves completely across the controller screen from left to right as if it was going to spin up the props but nothing happens and there are no warning sounds , error alarms, or warning lights from either the tx or the quad.
Any ideas?
I did Re-seat all three SD cards( 1in controller, 2 in Solo (1 on wifi card ,1 on Pixhawk) and successfully performed a factory reset, as well as a successful level and a compass calibration.
Everything seems to be in order . The lights inside controller and on the Solo show a successful boot sequence. I get GPS lock , Yet the motors are unresponsive to PRESSING AND HOLDING THE FLY button.
I'm stumped.
Any ideas?
I did Re-seat all three SD cards( 1in controller, 2 in Solo (1 on wifi card ,1 on Pixhawk) and successfully performed a factory reset, as well as a successful level and a compass calibration.
Everything seems to be in order . The lights inside controller and on the Solo show a successful boot sequence. I get GPS lock , Yet the motors are unresponsive to PRESSING AND HOLDING THE FLY button.
I'm stumped.