Long time lurker, first time poster....
I own two SOLO UAV's and have had no real issues that I wold consider abnormal for any UAV until Friday.
SOLO #1 was involved in a low alt impact with an object and crashed.... No damage other than one lost prop. SOLO landed on its legs after crash. Powered unit down, went home and put it away.
Fast forward to Saturday afternoon and I went flying again. Upon power up SOLO immediately says "Magnetic Interference" and obviously wont go further.
I tried doing the compass calibration via connected iPad Mini and it always fails... the green status bar gets exactly half way across the screen and then go no further, then ultimately fails.
I have tried moving the compass leg from SOLO #2 to SOLO #1 and the error persists and will not calibrate.
I even flew SOLO #2 with the compass leg from SOLO #1 and it calibrated and flew fine....
I have opened a ticket with 3DR but was hoping someone here could help.
Thanks in advance
I own two SOLO UAV's and have had no real issues that I wold consider abnormal for any UAV until Friday.
SOLO #1 was involved in a low alt impact with an object and crashed.... No damage other than one lost prop. SOLO landed on its legs after crash. Powered unit down, went home and put it away.
Fast forward to Saturday afternoon and I went flying again. Upon power up SOLO immediately says "Magnetic Interference" and obviously wont go further.
I tried doing the compass calibration via connected iPad Mini and it always fails... the green status bar gets exactly half way across the screen and then go no further, then ultimately fails.
I have tried moving the compass leg from SOLO #2 to SOLO #1 and the error persists and will not calibrate.
I even flew SOLO #2 with the compass leg from SOLO #1 and it calibrated and flew fine....
I have opened a ticket with 3DR but was hoping someone here could help.
Thanks in advance