Hello,
I'm trying to figure out the process for connecting a Micasense Rededge camera to the Solo accessory bay so I can remotely trigger image captures as well as pull images for analysis. From what I've read on the Rededge http API and their integration guide, I need to use the camera's H4 8 pin serial/ethernet port and connect that to the Solo's accessory bay.
I've never done something like this before and was hoping someone could point me in the right direction so I don't brick my drone and camera. Is a breakout board required? Can I just solder to the mating connector they recommend from mouser.com? Do I need to solder anything to Solo's main board?
Thanks for your time!
RedEdge HTTP API
I'm trying to figure out the process for connecting a Micasense Rededge camera to the Solo accessory bay so I can remotely trigger image captures as well as pull images for analysis. From what I've read on the Rededge http API and their integration guide, I need to use the camera's H4 8 pin serial/ethernet port and connect that to the Solo's accessory bay.
I've never done something like this before and was hoping someone could point me in the right direction so I don't brick my drone and camera. Is a breakout board required? Can I just solder to the mating connector they recommend from mouser.com? Do I need to solder anything to Solo's main board?
Thanks for your time!
RedEdge HTTP API