SO _LO FRUSTRATED!

[Soupdaddy]

I finally go tpast this and this is how

1- Power off the units and close the Solo app
2- Perform a factory reset to the Solo and controller, make sure the orange light underneath the Solo blinks faster during the reset process.
- Factory Reset | 3DR - Drone & UAV Technology
3- Once the units are reset connect to the Sololink but do not open the Solo app
4- Make sure the Orange light underneath the Solo is blinking slowly, if so, please perform the following:
- Please, press the pair button for 1 sec and look at the controller screen for the "detected new Solo" message
Once you see the message "detected new Solo perform the following: Press A, then B and hold both buttons down. Once the Controller vibrates, you can let go. Within 20 seconds, the Controller will show “Solo Paired."
5- Once the Solo and controller are paired, please, confirm the orange light underneath the Solo is solid now
6- Open the Solo app >> settings >> updates >> start the update
7 Once the update process finishes, please, restart the Solo app

following ALL these steps exactly worked for me, all good now.
hope this helps the next pilot with preflight update issues .
Cheers and thanks for the input!!