Radio Error

[Josh]

Hi All,
Im new to pixhawk and in honesty am a little out of my depth. Im trying to configure my radio (spec dx9) and do the calibration. The green bars are coming up but when i go to finish the calibration I'm getting a Invalid PWM error. I have been searching the forums but have had little luck. Any help would be greatly appreciated.

Your friend in the sky

Josh

 

[Earldgrayjr]

This is "probably" not the place for those answers...

If you haven't already, you might try here

http://copter.ardupilot.com/

or here

http://www.rcgroups.com/forums/index.php

 

[Rich]

I don't have a DX9, so this is just a guess.

First, be sure you have a fresh profile on the DX9, or pick a new Airplane type of profile and don't touch the end points, etc.

Here are the specific instructions on radio calibration: http://copter.ardupilot.com/wiki/initial-setup/configuring-hardware/#calibrate_radio_control

Then see if this helps.

 

[Rich]

Josh, did you solve this issue?