New to Solo.
Did all setups, software updates ect. Was out at the field doing some preflight checks and have some questions.
1) Condition. Solo on flat surface without props. Start motors. Mode :FLY
Problem? I noticed different motors spooling up and down (usally one or two)..i was expecting this if i tipped
the solo or operated the controller unit but not on flat surface.
Question1: should i be worried?
2) Condition: Solo being carried, no props, motors running , Mode = Fly,
Problem? Motors seemed to randomly shut off. Must start over (new flight) to get motors to start...(ie
Press start to start motors, hold to take off)
Observation: When i turned on voice on my android device it stated "collision detected". Wasn't able to
consistantly tip or bump to definite reproduce. .. There is a utube video in mountainous area
which shows solo power shutoff in flight (the situation i want to avoid)
Question: What parameters are looked at for "collision detected" fault? Is this normal??
3) Condition: Solo motors running without props. Mode Fly, Press to land ....activated.
Problem: I was climbing ladder (altitude going up) and motors shut off after a few seconds.
Question: Is this right?? What controls the auto land??
Any experienced help will be greatly appreciated!
T
Did all setups, software updates ect. Was out at the field doing some preflight checks and have some questions.
1) Condition. Solo on flat surface without props. Start motors. Mode :FLY
Problem? I noticed different motors spooling up and down (usally one or two)..i was expecting this if i tipped
the solo or operated the controller unit but not on flat surface.
Question1: should i be worried?
2) Condition: Solo being carried, no props, motors running , Mode = Fly,
Problem? Motors seemed to randomly shut off. Must start over (new flight) to get motors to start...(ie
Press start to start motors, hold to take off)
Observation: When i turned on voice on my android device it stated "collision detected". Wasn't able to
consistantly tip or bump to definite reproduce. .. There is a utube video in mountainous area
which shows solo power shutoff in flight (the situation i want to avoid)
Question: What parameters are looked at for "collision detected" fault? Is this normal??
3) Condition: Solo motors running without props. Mode Fly, Press to land ....activated.
Problem: I was climbing ladder (altitude going up) and motors shut off after a few seconds.
Question: Is this right?? What controls the auto land??
Any experienced help will be greatly appreciated!
T