Level calibration error after upgrading to open solo 3.0 via solex

[Pedals2Paddles]

It's not the gimbal and it's not the controller. If the proper firmware has been installed, and parameters have been reset, then my suggestion is that the cube has a hardware failure of some kind and needs to be replaced.

 

[BRBpromotions]

It's not the gimbal and it's not the controller. If the proper firmware has been installed, and parameters have been reset, then my suggestion is that the cube has a hardware failure of some kind and needs to be replaced.

Is there a way to know for sure on the cube? When it's connected to Mission Planner, the artificial horizon seems to read as I believe it should.