- Joined
- Oct 11, 2016
- Messages
- 7
- Reaction score
- 1
- Age
- 66
hi, would appreciate advice if possible, had smal crash (pilot error, long story short distracted momentarily by attractive lady getting out of car) props touched stationary object while hovering 12 inches off ground, drone flipped and hit the floor, everything worked fine afterwards, however next flight i couldnt get a picture from my go pro, on further examination i discovered the female connection plug on the gimbal circuit board had become detached, the pegs which hold it in place had just come out of the solder, and there appears to be a number of other connections underneath, does anyone know if these, are just touch contacts, or should they be soldered too, i cant see a way to get to them, but should be easy enough to solder the 4 pegs back in (and do a better job than 3Dr as the solder hadnt run in to the retaining holes in the connector legs and had formed a pretty week joint (granted crashing didnt help matters) So if i solder the 4 pins back will it work? I think i already know the answer but i live in hope !