Gimbal video lock up issue

[ProStock]

Well last night i was flying just fine and notice somes video lock up
I land it and i was not able to get the video back till i reboot Solo
then i notice if i turn the gimbal main arm to the right the video feed lock up
and if i move the oposite way it resume video feed
and if i keep it lock too long i have to reboot solo video won't resume
so my guess is it the HDMI internal Gimbal Strap ?
Thx for the help guys!
PS: i test the HDMI cable no issue i shake it no video loss

 

[erikgraham]

It's probably a bad idea to move the gimbal arm while it is on. You'll burn out the motors. I wouldn't do that anymore. Gimbals are sensitive instruments.

I suggest you remove the gimbal and reinstall it, making sure to carefully route the cables as shown in the 3dr help video.

I'd also hard restart your GoPro by pulling the battery out of your GoPro for 15 seconds and then reinstalling it.

Good luck. Post back here if you continue to have problems.

 

[ProStock]

to do the test
the connector that give power to servos motors was dissconnected
only the HDMI was connected to do the the test & move arm right = lock up