Hello everyone and happy new year!
The question is about connector on the board of the gimbal that shown on picture. Its broken and i cannot find it in my local stores. Did enyone knows serial number or part number to find it on ebay/ali?
Before you jack-up removing the screw holding on the yaw arm, remove the 1.3mm allen grub screw from the base of the shaft.... I see the screw head is already somewhat stripped.
I have not been able to source the exact FPC/FFC connector as of yet. Both Digikey and Mouser have a selection, but the anchor to pad layout is off for what they carry. I expanded the anchor pads with some copper shim stock, it seems to work but the board or ribbon I have appears bad...not sure but couldn't get it to work.
Further the solder pads rip real easy, so know what you are doing before you crap the board. I tried soldering in jumpers on another board, but that was a fail. The traces run on both sides of the board to the HDMI connector. Plus the narrow spacing on the terminal pins leaves little room for error.