Hi folks, just got my Solo about a week ago. Worked great right out of the box. I installed mission planner on my windows laptop and started playing around. Because I am an idiot I went through the wizard and some other things. Rebooted the Solo and it started beeping, beep code seemed to indicate low battery although it was fully charged. I went through the rest procedure by searching for the sysid setting and changing from 120 to 0.
I then reset Solo and controller and all was fine until the solo and controller updated. Now I have another constant beeping although different this time. Seems to correspond to when the Solo starts looking fro satellites. No satellites are shown on the controller. Did a calibration and the beeping stops for a few seconds then starts again. I seemed to have messed this up good. I have already opened a support ticket with 3DR but no reply yet.
Any ideas?
Thanks!
I then reset Solo and controller and all was fine until the solo and controller updated. Now I have another constant beeping although different this time. Seems to correspond to when the Solo starts looking fro satellites. No satellites are shown on the controller. Did a calibration and the beeping stops for a few seconds then starts again. I seemed to have messed this up good. I have already opened a support ticket with 3DR but no reply yet.
Any ideas?
Thanks!