I'm trying to figure out what happened here. Tech support told me to perform a level calibration which I did earlier today. I had 2 great flights yesterday without issue. Anyway, after I did the level calibration I wanted to look at the old and new parameters becuase I couldn't see the offset that the 3DR tech had mentioned I had on my Z axis.
Anyway, I used an online tool to compare 2 files and was suprised that dozens of parameters are different. I know parameters change but there hasn't been an update to Solo. Last update was to 3DR services and prior to that was the 1.1.1 version of the app.
Nothing's changed in the past 2 days so I'm worries that something is causing the parameters to change. I have been fooling with Mission Planner looking at TLOGS and such but have not done any parameter changes, loads or pushes to the Solo. Is there anything in mission planner that can actually change parameters without you actually realizing that its happening? Most of the time I dont connect Mission Planner to Solo as I use it just to look at logs. I connected a few minutes ago to check out the parameers area and it seems you would have to purposly load or change parameters and then upload them to Solo while its connected and I know I haven't done any of that.
Is there anything that logs "when and how" parameters were changed? Can someone please post the current parameters so I can put them back?
Here are all the differences that my tlog parameter extracts are showing: Are they supposed to change between reboots?
Diff Checker
Anyway, I used an online tool to compare 2 files and was suprised that dozens of parameters are different. I know parameters change but there hasn't been an update to Solo. Last update was to 3DR services and prior to that was the 1.1.1 version of the app.
Nothing's changed in the past 2 days so I'm worries that something is causing the parameters to change. I have been fooling with Mission Planner looking at TLOGS and such but have not done any parameter changes, loads or pushes to the Solo. Is there anything in mission planner that can actually change parameters without you actually realizing that its happening? Most of the time I dont connect Mission Planner to Solo as I use it just to look at logs. I connected a few minutes ago to check out the parameers area and it seems you would have to purposly load or change parameters and then upload them to Solo while its connected and I know I haven't done any of that.
Is there anything that logs "when and how" parameters were changed? Can someone please post the current parameters so I can put them back?
Here are all the differences that my tlog parameter extracts are showing: Are they supposed to change between reboots?
Diff Checker
Last edited: