Aaahhhh how frustrating.
All of a sudden I started getting the waiting message that never goes away.
So far I have:removed the controller battery for 3 minutes reseated said battery rebooted to the same message.
Next i removed and reseated with hot glued the SD card rebooted the solo and controller to the same message.
Next I bought a new controller. When it arrived i charged it fully reset the solo and controller.
Amazing controller said found new solo so i pressed the a b combination,it paired. I then used the solo app to update and that wen smoothly until the the screen says "solo and the controller are ready" to receive the update all you have to do is press BEGIN the transfer..
So i press BEGIN only to have the phone tell me it does not detect the solo/ please check to assure that the two devices are connected. Well why wouldnt they be still connected ?
There is no wreck history or hard landings on the drone and the problem just started
Any one out there have any suggestions for this PLEASE.
missing information. the controller has a solid red a solid green and an orange that flashes at 2 x a second
the solo starts up and all the light sequences are good up to the green x4 cause the led's flash 2 times then go red rear(see photo) and pale BLUE in front. When i try a hard reset the solo gives a flashing orange light but it never pairs.
any sound advise would be greatly appreciated
All of a sudden I started getting the waiting message that never goes away.
So far I have:removed the controller battery for 3 minutes reseated said battery rebooted to the same message.
Next i removed and reseated with hot glued the SD card rebooted the solo and controller to the same message.
Next I bought a new controller. When it arrived i charged it fully reset the solo and controller.
Amazing controller said found new solo so i pressed the a b combination,it paired. I then used the solo app to update and that wen smoothly until the the screen says "solo and the controller are ready" to receive the update all you have to do is press BEGIN the transfer..
So i press BEGIN only to have the phone tell me it does not detect the solo/ please check to assure that the two devices are connected. Well why wouldnt they be still connected ?
There is no wreck history or hard landings on the drone and the problem just started
Any one out there have any suggestions for this PLEASE.
missing information. the controller has a solid red a solid green and an orange that flashes at 2 x a second
the solo starts up and all the light sequences are good up to the green x4 cause the led's flash 2 times then go red rear(see photo) and pale BLUE in front. When i try a hard reset the solo gives a flashing orange light but it never pairs.
any sound advise would be greatly appreciated
Last edited: