after changing serial 2 cannot connect controller and solo

[Taro]

I connect my solo by WiFi from mission planner on the pc .
I changed some serial 2 settings. After that, mission planner cannot connect to solo and the worse, controller cannot connect solo.
Once turn on the solo, all LEDs turn to green and not turn off.
Manual says my solo failed to start up.
What should I do?
Anyone please help me.

 

[just_bruce]

Check that the solo doesn't just need pairing first.

THEN try either connecting to the cube directly with USB & MP or resetting the parameters with the button in the gimbal bay.

If that fails try a factory reset on both bird and controller.

The lesson would be don't go fiddling about with parameters unless you KNOW what the result will be.

 

[IrishmanPDX]

I know what the result will be:

A: you'll mess up your solo
B: You'll make a nice solo indentation on either the side of your house or a tree.

 

[Taro]

Check that the solo doesn't just need pairing first.

THEN try either connecting to the cube directly with USB & MP or resetting the parameters with the button in the gimbal bay.

If that fails try a factory reset on both bird and controller.

The lesson would be don't go fiddling about with parameters unless you KNOW what the result will be.

Hi just_bruce,
Thank you for teaching me.
Resetting the parameters by pushing SSWT button worked.
(I had to push the button first and turn on 3dr solo after that)
At beginning, 3dr solo and controller didn't connect so I tried to do pairing, and somehow they suddenly connected (I didn't understood what happened).
Then I connected mission planner and turn the parameters back to the original value.

I almost gave up, really appreciated your help.
Thank you.