Picked up a couple of Iris plus. They were both neglected but finally got both flying. Everything is now as it should except telemetry.
I Can’t get the 3dr radios to connect or see each other. First time using these so have no clue. I can connect to them alone with MP and updated firmware to 2.0 and change the channel so they both match but they blink green and won’t connect. I actually have four of them. One in each drone and two out. They appear to be original 3dr. All four are exactly the same. Tried a couple of channels, both matching and also mavlink and raw to no avail.
I also can’t get telemetry from the Tx Rx. Nothing shows up in the telemetry page within OpenTx. The Rx is hooked up as it should with sbus to pixi and the connector on the side for analog telemetry. The jumper is also where it should be according to the manual.
Hoping someone here can point me in the right direction.
I Can’t get the 3dr radios to connect or see each other. First time using these so have no clue. I can connect to them alone with MP and updated firmware to 2.0 and change the channel so they both match but they blink green and won’t connect. I actually have four of them. One in each drone and two out. They appear to be original 3dr. All four are exactly the same. Tried a couple of channels, both matching and also mavlink and raw to no avail.
I also can’t get telemetry from the Tx Rx. Nothing shows up in the telemetry page within OpenTx. The Rx is hooked up as it should with sbus to pixi and the connector on the side for analog telemetry. The jumper is also where it should be according to the manual.
Hoping someone here can point me in the right direction.
