Recent content by SolidWrecks

Hello, I have a indoor positioning system that can share the positioning of the Solo and need a way to pipe this into the Solo so I can fly Guided indoors without GPS. Is anyone able to share a way I can send XYZ, velocity and covariance and GDOP to the Solo over Serial 2 or some other means...

Thanks for the free bump but seriously, this is kiling me. I think this should probably move to solo help.

Hi, I had to reset my solo and now the gimbal just sets with a bliking yellow light. Any ideas on what to do? I have read that blinking yellow means booting up. Is there a way to reset the gimbal?

I moved the ports forward some. Now they are next to the gimbal.

Low gain dipole antennae. Will get CP clover antennae at some point

Not yet. Wanted to isolate the variables. I'll do that and see if it fixes it. If not, I'll put the old cards back in I guess.

I hot glued them in place. The signal comes back fine after a power cycle.

It flew fine. The range was pretty bad if wifi was close which is why I did the mod. 3dr says I'm on my own since that presume it was caused by my mod. I can't challenge that fact.

Hello, I've exhausted 3DR support on this issue. I hope people here can help as I'm looking at something like a broken drone. I will explain it as best as I can. I've upgraded the wifi cards in the solo and on the controller and added external antenna ports. Now, it will fly and what not...

Looks like you get a free battery.