Solo flight mode AUTO using QGC ground control

[dougputt]

Hi

Trying to figure out a way to resume a mission from the controller after I've already uploaded the flight from QGC..

Or can I take off manually, hover to a point and then switch to auto mode to start the mission? Reason I'm asking is I'm trying to fly two solos on the same corridor scan but at different altitudes...I want to make sure they are both airborne and at alt before I commence it.

Can I set Solo through parameters in QGC to have the A or B button as auto, or double press or something?


Best

 

[dougputt]

disregard...found it...long press on A returns to auto mode..

Beautiful