snap rings

[pyrate]

Guys
What are you using for 4mm shaft snap rings?
All the ones I see on Amazon look huge?

 

[RichWest]

I assume for your 4mm T-Motors shaft....

From the link below, 4mm shaft dia. you then have two options for snap rings styles.

McMaster-Carr

OR an easier option, because they are T-Motor branded...

C-Clips - For 4mm Motor Shafts (10pcs) [CC003] - $1.59 : Ready Made RC LLC, The Leader in All Things FPV, RC, and Beyond
Washers - for 4MM Motor Shafts (10pcs, steel) [WA002] - $1.59 : Ready Made RC LLC, The Leader in All Things FPV, RC, and Beyond

 

[pyrate]

My bad Rich, I got the clips, its getting them off and on I am struggling with
all the snap ring pliers I see are way to big

 

[RichWest]

Those funky looking ones, like a figure 8? If so, I've never been able to reuse them once installed, one shot usage. They are a pain to install, must be a trick to installing them....

I bought this style of pliers for the stock 1/8" cir-clips and they work well. Here are the ones for 4mm clips...either should work. Tips are the correct size for the funky clips... I bought the 45 angle ones...

McMaster-Carr

 

[pyrate]

Still cheaper than a 70 dollar motor

 

[RichWest]

Still cheaper than a 70 dollar motor

No doubt, good luck on the install...