I'm making some breakout boards to expose all the pwm outputs on the PH2. It will be a stack able board that fits between the PH2 and the carrier board. I may add a power rail as well so it can drive cyclic servos but not sure yet.
As it is a stack design it probably wont fit in a solo but for transplants into other air-frames it wont be an issue.
It will not access anything on the companion computer..just all of the PH2 pwm pins.
If there is any interest here I'll get more made and pass them on at cost.
I'll start on the design later this week and hopefully have it ready to send out next week for production.
If it's just for me I'll most likely use OSH park for a small order but if its more than 10 probably seedstudio.
As it is a stack design it probably wont fit in a solo but for transplants into other air-frames it wont be an issue.
It will not access anything on the companion computer..just all of the PH2 pwm pins.
If there is any interest here I'll get more made and pass them on at cost.
I'll start on the design later this week and hopefully have it ready to send out next week for production.
If it's just for me I'll most likely use OSH park for a small order but if its more than 10 probably seedstudio.
