Recent content by ProStock

i use solex to retrive the log's is there another way to retive the dataflash log those dataflash log are they located in log folder also i check all the dataflash logs using mission planner all of thems have 0:00 duration i upload all the logs solex provide me log.zip

i'm not too familiar with log's let me know if this is the right log thx for helping

Gees no ones can help?

Well need help with my Solo Can you guys tell me what's going on Check the flight log @ 92% it was at 12 inches of the ground when it stop to wobble down losing altitude fast Thx for your helping hands PS: i have attach the log

Thank you or Like Will do :)

Great Dart Now Hmmm what's the majic word ;)

there's no antennas included https://www.amazon.com/dp/B00V9E99QW/ref=psdc_172544_t1_B009UMQ23I FrSky Receiver Antenna 25 cm FrSky Receiver Antenna 40 cm

Brown outs of the ESC are caused by a ground floating on the ESC side which leads to the ESC shutting down. will mostly show on master, not that much on stock fw. Problem with the WiFi card on the solo is a reboot from the pixhawk from a voltage drop on the low voltage. 3DR SOLO Diary-14-Swap...

if im right it's not recommended to install Mikrotik R11e-2HnD in the Solo power used by the card can do damage to the IMU or iMX.6 not shure witch ones it's not recommended to install Mikrotik R11e-2HnDonly in the Solo Controller just my 2 cents infos here's somes infos about it Log into...

Thx for your offer but theys ares avail for $28 at MikroTik 802.11b/g/n 2GHz 800mW MiniPCI-Express Wireless Card (with 2 uFL connectors)

Pyrate got a question for you did you built your self a Tarrot ?

Thx guys i dont need card anymore

Well my KDE motors runs great still but this products as been discontinued you can still buy thems at KDE Website but theys asking $61 eachs + SH you better go with T-Motor 2216-12 800kV OR SUNNYSKY X2216 880

Do you see what i see :) This is a MOD im about to do as soon i recived the cam at $69 shipping included i can't resist It need somes Dremel work around as seen in the picture Orange highlights the 4 posts that holds the lense pcb need to be shaved a bit to to make room for the GP bus connector...

SOLD