Recent content by Earldgrayjr

Have several Solo's. Some only set up/tested then put away for several years now. Opened them up for eventual sale recently and realized I had changed and forgotten the passwords. I am an IOS/PC user and given it has been several years and the app is no longer available, that presented a...

Test... This is only a test.

Wow. Impressive :)

Yes. For Solo the Telemetry Logs (tlogs) are on the craft, as well as in Tower if you use that. They can be played by Mission Planner regardless of where you get them. There are a number of ways to get them, from emailing them to yourself, to connecting the tablet to the PC via USB. On...

I I do agree that this is one place the Go app shines. Unfortunately, it doesn't have many options, and getting into the logs (other than this) yourself. It is good ffor showing where you went, but is not very functional for dignostics. There are a few options currently with solo for...

Yowww... That looks painful. Sorry man...I hope it works out well for you..

Yes... But even correcting yaw, if the motor isn't vibrating, or vibrating less, then that woukld matter. Even with yaw, vibration can be the underlying cause. In my mind, you have two choices. Eliminate it at it's source and/or stop it's transmition to your camera, I have done a few...

Yah that is the bad thing about multi's. ZERO glide... The only good news is that the Solo is turning out to be a bit like Joe Frazier (for you old guys). It can take a real beaten, and survive.

The thing is going to be flying your Solo. A listed tablet is $150. Your call.

Not listed. Don't think it would load.

Looks like complete loss of power to me...

I was going to say..... And he broke his neck... The End :)

Nope. You just have to send a check to me!! No... :) Just connect WiFi to cache the maps of where your mission will be

Haven't heard of firmware causing shakes. My advice is look at the Solo. Is it shaking? Vibrating? Be careful, but touch it. Legs vibrating? Gimbal? Front? Back? If you have balanced props, my bet is it is motors needing balance. That doesn't mean it is a bad motor. Same as props...

If it doesn't sit flat and level with the power off, it is best to balance it. Typically weights are needed on the far end of the gimbal furthest from the GoPro and at the lower left back of the GoPro. Your gimbal will thank you.