Recent content by Boracay

Try searching at DJI forums, if you haven't done that.

Ha. It would take awhile to get there in Asia. What drones are available there?

Taga diin ka sa aton? It would take awhile because it is made in US. Kung made China te basi una pa dira .

Hello. Yes. I'm from Iloilo & used to go to the place every summer / holyweek.

I was at the PhotoPlus Expo in NY this morning. I talked with the 3DR representative & gave some promising future updates for the Solo for the upcoming months. First is the bigger capacity battery for longer flights. Bigger means heavier. Which they will have a big motor upgrade too. New gimbals...

Thanks Walter! I'll take a look at it.

Very neat & full pack! Any third party mount for those FPVLR? How do you mount it?

I used these to remove the prop. 3mm accessory rope for climbing. Wrench that came free on Ikea furnitures & it's like made for the Solo prop. I just insert the rope on the motor case hole & hold it for leverage then use the wrench. You can use any rope that would fit in the motor case hole &...

NIce!

That's nice mount Earl! I am supposed to go on this route but I find it too big & i have to take it out everytime I store it. Anyways, did I post big file photos? I can't see it anymore even the attachments. Thanks.

Thanks for the info guys! Greatly appreciated.

Thanks Adi! Btw, Check out my little project that might solves everyone's dilemma.

I found a solution that you can mount any tablet size in your Solo controller. I've been using this mount sinced iPhone 4 came out. It has a very solid mount. It just need a little elbow grease. First i took out the phone/tablet clamp from the rotating arm. Then I place this mount in the...

I don't know if anyone noticed that the gimbal comes with a set of 4 different counter weights, in a small box together with the gopro lens hood? These are used to balance the gopro in the center as much as possible. Same as DSLR's on a Gimbal/Slidecam, it uses weight to counter balance the...

Hello. New solo pilot here. Good to bump in this forum, a lot of information & ideas. Hope to gain some & share some. Got a first Q. Please direct me to thread if this was ask before or been discussed. Is there any third party vendor for a carbon fiber prop? Thanks!