Im amaze there's no shaft puller available on the market yet
LOL... I was thinking collet type puller at first, but thought about the potential for marks. If your replacing the shaft who cares, if re-use then I'd look else where...just me... I'd buy a set of shafts just in case....if you use the rivet gun.Ghetto Puller
Hmmm this might work hey ?
Curious, was it the Black indicated CW motor that you replaced?Ho yes that will be also a good way toget it out thx
Last times i service the motors i replace all the bearings top and bottom
with Jap NMB Bearings
And it makes a huge improvements on noises and vibrations
only the shafts have not been replaced
3DR send me a Motor Pod replacement a while ago and brand new out of the box
it's louder and vibrations ares higher
We use essential cookies to make this site work, and optional cookies to enhance your experience.