I am telling you. You really should buy this. It snaps right on (the four pronged hooks) in place of the existing, in two seconds and will hold any tablet of any size (including protective case) very securely. No drilling or screwing necessary.I now can fit my air 2 tablet with its case on my controller. Just take apart your holder on your controller and drill 2 new holes on the bottom bracket lower than the stock holes and file or exacto knife the slots in the holes. Then on the upper bracket exacto knife the slots longer to let the bracket slide longer. just leave the springs in the same spot my springs streatch out a bit but worked out fine.
The ball socket on the aftermarket iPad holder was slightly smaller, however after tightening the nut it is very secure - MUCH better than having iPad pop out of factory spring loaded phone mountSo the ball on that one is the same size, and fits the same as stock? My 8" tablet moves sometimes and I have to adjust it or tighten the ball on mine. Does this seem more secure than stock as far as the tablet weight moving it?
Even better!! This thing has the same 4 plastic hooks as the stock clamp. It snaps right on. I cranked down the ball on mine, and put this on, and it hasn't moved since. This will hold any size tablet, including a protective cover.So the ball on that one is the same size, and fits the same as stock? My 8" tablet moves sometimes and I have to adjust it or tighten the ball on mine. Does this seem more secure than stock as far as the tablet weight moving it?
We use essential cookies to make this site work, and optional cookies to enhance your experience.