- Joined
- Feb 2, 2017
- Messages
- 2
- Reaction score
- 0
- Age
- 37
ok SO im just purchased the 3dr solo it came in the mail last night. I took it out for a flight it performed a little slow and laggy but i think i might have to do with it being cold and windy... but i flew it for 15 minutes.. then I hit the rth button it shot into the sky and proceeded back to the takeoff point atleast close to it. except off by few feet. as it proceeds to land i notice it heading for power line. I try to hit the pause /brake button but it was too late. CRASH!!!!!! hits the power line gets tangled, then falls about 20 fight to the ground. suprisingly only damage that it has is a cracked arm nothing really noticeable. but as I go to get the drone to power up again after chargin for another flight I noticed that Motor pod 1 isnt spinning at all. the lights signal and indicate that everything is ok. then it detects a crash I make a support ticket and explain everything i just did and i talk to 3dr support to find it can take u pto a week or two for it to be reviewed. How do i know if its just the motor or is it the flight controller or circuit board. Ive taken out the motor pod and it seems fine and in tact but It still wont spin once im armed for flight. What can be the problem? Will 3dr replace my motor pod?