Hello all,
My spare drone that I had was undusted and sold on eBay but before I shipped it out, I tested it. The gimbal would not stabilize when powered on and would even rotate side to side and hit the ground. I swapped a known good gimbal from my other drone and it worked perfectly. So I sent that gimbal to the buyer and now I'm stuck with a seemingly broken gimbal.
I tried doing level calibrations, compass calibrations, resetting parameters, factory reset, made sure the gimbal was balanced correctly, it sits level when the solo is off but then goes haywire when its on.
The gimbal pretty much moves every which way but avoids being level.
I made sure the wires were ran correctly and didn't interfere with anything.
I have another new gimbal that's still factory sealed which I would like to keep sealed since they sell for $100+ on ebay.
So any tips? Sorry probably TMI
My spare drone that I had was undusted and sold on eBay but before I shipped it out, I tested it. The gimbal would not stabilize when powered on and would even rotate side to side and hit the ground. I swapped a known good gimbal from my other drone and it worked perfectly. So I sent that gimbal to the buyer and now I'm stuck with a seemingly broken gimbal.
I tried doing level calibrations, compass calibrations, resetting parameters, factory reset, made sure the gimbal was balanced correctly, it sits level when the solo is off but then goes haywire when its on.
The gimbal pretty much moves every which way but avoids being level.
I made sure the wires were ran correctly and didn't interfere with anything.
I have another new gimbal that's still factory sealed which I would like to keep sealed since they sell for $100+ on ebay.
So any tips? Sorry probably TMI