Recent content by tinker bot

Thanks for sharing that. Not sure if it's just me, but the footage using the ND8 filter seems so much more clear than the others, even when panning. What are your thoughts? How often do you use it and in what circumstances?

Good to know. Thanks for the follow up.

Thanks man, am learning as i go. I was using Facebook for a bit because it was working until it didn't :) You are right things disappear fast. I did as you said and other than an ironic bit of damage i did to the paddle wire :) my error is gone. Thanks again!.

*** SOLVED *** I cannot get this corrected and I tried the calibration, any help is appreciated. Below are my posts on FB Solo Group and the video I followed to calibrate sticks. Security Check Required Here are a few of my posts from FB in case you cannot access them via the link above...

Maybe it doesnt apply to your situation but toward the top of this link where I and others comment on what seems a similar concern to yours, there is a picture that shows what I was talking about https://3drpilots.com/threads/gitup-git2-camera-live-view.6910/#post-98925

you can very carefully shave down the plastic of the gimbal that the rubber/HDMI cable wraps around.

Thanks for posting, just what I was looking for.

I am not sure where I got the info that the non ribbon cable wires to the accessory bay were the power, but it now appears wires 1 & 2 of the ribbon cable "are" power? There may be other wires that carry power. I have no idea what the other wires are for, but I tried my polar pro LED lights...

Hi, I used the following as my primary training drone and still love to fly it. https://www.amazon.com/Hubsan-H107L-Channel-2-4GHz-Quadcopter/dp/B00IZC6C8E/ref=sr_1_fkmr0_1?ie=UTF8&qid=1506868805&sr=8-1-fkmr0&keywords=hubson+x4+h501L You can get it if for apx $25 if you look around. I have...

Thanks and no worries. It helped to have it confirmed that the solder "burn marks" were due to hand soldering and nothing more! I will post back when I get a little further into some trouble shooting I have planned in an attempt to prevent damage to my coming replacement main board, if at all...

The alcohol helped a little. The ribbon cable pulled off while cleaning contacts, bummer! I ordered a new board with the accessory bay attached to it via the ribbon cable. Not sure why the bay wouldn't have simply powered the polar pro lights, but I have new board coming and if it fixes it...

I will clean up the solder points with some alcahol and see if i can determine where the break is. Anybody know if the power that is supplied to the accessory port is through the ribbon cable or the other set of wires between the accessory port and the main board?

So I finally got around to opening my main solo up again to upgrade to the green cube and while doing so I looked around for any bad connection points on the accessory port which has not worked. This particular picture is not of the ribbon cable solder connection points, but a picture of...

Fun Stuff.

I do not know, but if anyone dives in and finds some pricing on the components I am sure some one will benefit from current pricing info being listed here.