Recent content by Proficnc

For reference, the section that burned was the main system power supply. The GPS is supplied from the PSM, which is the little module that sits above the cube between the 4 cube mounting screws.

A bit of both... But regardless, neither should be an issue... if the esc was correctly referenced. But it's not... So the two possible fixes were... An opto coupler on the ESC... (best option) Increasing the voltage of the signal. (Green cube)

There is a new Safe RTL (or smartRTL) function coming... will be betterer

Atmega8A Most of the above is on average correct... A few points... It is "Ground Lift" The Solo ESCs at full power can draw nearly 50A.... that is right... 50A. So 1V lift doesn't seam so bad now does it :) The issue is an errata on the ATMega8A... It sees a TTL high as >2.4V However it...

wow, Thanks for this load of lies! The green cube is offered as a NON plug and play solution, but thanks to the efforts of Matt, FOR FREE, and Kelly, for na additional charge... it is almost plug and play now if you follow the instructions that Matt has provided. YES I USE CAPS.... sometimes...

All the stores are listed below the map, their stores are listed with their logo. Please just pick a store closest to your location.

That is the correct one for Iris, but purchase from your nearest distributor, not on my store... For solo, there will be a special listing coming soon

You need the suite. It comes with cables to fit your Iris+ Please buy from your local reseller, you can find a reseller at www.proficnc.com/stores Thanks

Hi All Yes, this cube is a special version with 5v PWM out. Other features already listed above... It will be listed in the proficnc.com store soon.

No, this GPS fixes all the issues with the GPS. No comparison to the old GPS. This thing is awesome! It has all the recommended fixes that were recommended by engineering since before release!

Lol!

The instructional is actually on discuss.ardupilot.org

It's in the solo mod club if you want it :)

Yeah, looks like an admin needs to approve the link or something...

Hi All As promised, here is the info on the optical flow mod that I did for NAB All discussions will be on the Ardupilot discussion forum for this one.... Security Check Required Thanks all