Recent content by olytthra

When I’m back at the lab tomorrow morning I will try using a telem link. When I took the solo apart today I checked the soldered pins on the ribbon cable. And made sure the cables inside were not broke by using a contuctivity tester. So I’m pretty sure the accessory port is properly connected...

i took a glance at that list, what was it for? Thanks again for the help

I believe this is what you are referring to?

okay makes sense. but when i load the params onto mission planner those don't show up. do you know another way to access those?

when i connect through mission planner over solo wifi, it is able to download all of the params and ive checked that serial2 is enabled and has the correct baud thanks for help btw, ive been stuck on this for days. ive been working on this around the clock almost

im not getting anything. after serial2 is enabled for mavlink1 in mission planner, does the solo (after a restart) start transmitting immediately to serial2 or is there some sort of handshake that needs to happen? also i have seen on other forum posts that multiple gcs lead to problems with the...

ill try it. though i have the serial2 tx pin hooked up to an oscilloscope and there is only a constant 3.3v coming out, no matter what i send to the serial2 rx pin

I have bought and accessory port breakout board and I am attempting to communicate between a Raspberry Pi and the solo with MAVProxy over serial2 on the Solo. I have already connected to the Solo with Mission Planner over the solo wifi. In Mission Planner I have set SERIAL2_BAUD to 57600 and...