Recent content by nav-go

Great.. Thank you for your time!

I factory reset the Solo to try and fix the problem and it seems the opensolo was already loaded into memory as the default firmware , as the Solex app now says AP1.5.4 and everything else at 3.0.0. Everything is connected and paired. Has it fixed itself or do you recommend I try to reflash...

After rebooting controller and Solo, now controller now says "Solo and controller version mismatch" after pairing. Same error as before if I try to update copter through solex. How can I get the copter to OpenSolo now? Would appreciate some help with fixing this! Thanks!

It was paired, on stock firmware 1.3.1, flying and operational. Should I have updated to 1.5.4 before updating to OpenSolo?

Trying this on a Stock Solo with the Solex App. Controller update went smoothly. Copter update failed twice with this message: /home/root/postinstall.sh exited with code 1. Any idea on what this means? I am guessing the controller will not pair to the copter after next reboot? How do I update...

I have the pixhawk connected via USB. It lights up and keeps clicking, but neither QGC or MP is able to recognize it. Can I just upload the the default firmware onto the SD card? Is the pixhawk firmware different from the Solo's firmware? My previous plan was to just change back the baudrate...

I took out the Pixhawk cube from the board and connected it to my computer via USB but nothing lights up. Does the cube need to be connected to a carrier board in order to power up? Or have I completely fried the cube?

Thanks, I guess I'll try that. Then I'm going to switch to OpenSolo! What do you think is a good way to go about increasing the stream rate after I switch to OpenSolo? It seems to be possible in theory from I saw.

I changed the baudrate and the stream rate. Factory reset doesn't seem to fix it. Any idea how I can get this back to normal?

Thanks! I tried changing the SR1_ parameters with QGroundcontrol and MAV inspector shows the RAW_IMU rate increasing to upto 50 Hz. But disconnecting from the GCS returns the stream back to 2Hz. I tried rebooting the Solo and now it doesn't startup properly, getting stuck at 4 solid green...

Hello everyone. I'm working on a project where I'm using MAVROS to connect to the Solo and access its sensor data. But I'm only getting sensor data at ~10Hz. How do I increase the stream rate of the sensors through MAVLINK? Some googling shows that it can be done by meddling with the firmware a...