Recent content by Jun Mangahas

Just read a thread that 3DR is closing shop... @Maddog Thanks buddy I bought 2 of the 4. You might want to consider buying the last...

Just catching up. On this thread. I have not flown my bird since last January nor have I visited this forum until a few days back when suddenly my transmitter pack died and wont charge up fully. Now I know why i cant get batteries for my transmitter unless one of you guys can stir me in the...

Why is it that suddenly there is no battery option to buy the stock transmitter battery on 3DR's website or Best Buy. Suddenly my battery went from full to half and could not fly longer than 10 minutes. I have charged it overnight and it has not gone past half. Anyone had or having this problem...

This is not the first time I have heard of Motor Pod 3 causing a crash. I had a Motor Pod 3 failure too which led to my crash. Unfortunately I have been waiting for my SOLO to come back since late November. @3DR Support says it in the shipping department but I have yet to see it happen.

Of course I am not using or would even consider using the Taranis. That would be like stepping back 10 years if I did that.

@Rex Barlow No it will not get better read what Tony has to say below. The SOLO controller output is 100 mw. FPVLR said: ↑ All FPVLR antennas have an extremely good 50 Ohm impedance , for very good I mean at center frequency the SWR is < 1.1:1 , so it's world class, or you can say top notch...

@Rex Barlow Please read the above. Tony of FPVLR confirmed that you do not need an attenuator. Your set-up is fine.

@FPVLR Thank your Sir Tony. This is What I needed to hear and read. I have updated and added your answer on my other thread. Much appreciate your contribution to this hobby. How is your distance with the Sunhan WiFi Amp? | 3D Robotics Drone Forum

To all Amplifier users with the FPVLR antenna!!! This is the answer I have been looking for!!! As Per Tony of FPVLR and I quote from another thread; "Hi, for the Taranis you MUST use an attenuator because output power is 500mw and sunhans max input is about 120mw. You'd burn the amps, no...

Hi Tony, Thank you for chiming in. I am sure you have read my posts on both threads. While you say it is not not needed to use an attenuator between the SOLO transmitter and AMP the case is not the same with my testing of your antenna with the Sunhans amp on my Taranis. I needed to use an...

@ Rex, Read Post #5 and #7 of this thread.

@ Rex, You can buy the attenuator below and put it on the TX then connect your amp to it via the cable to the amp. 1pce SMA 2W male to female RF Coaxial Attenuator DC - 6.0GHz 3dB 50ohm

Hi Jubair, I fly in a high WiFi traffic causing me crashes with my planes so I added the amplifier not so much to go for distance but instead integrity of the signal to my plane. So I set-up my Taranis with a Sunhans amp last year but I was not so was successful with it until I met someone who...

@ Rex, What have you done to your Solo transmitter to make sure that your amp and antenna set up is matched to your transmitter to get maximum performance out of you amp and antenna upgrade? Hint: I do not see attenuators between your transmitter and amplifiers. Did you adjust anything inside...

Thank you for that link sir. I