Recent content by Jaicdc1

The first thing I will say in addition to my thread title, is That THE BATTERY CHARGER WORKS FINE, in fact it is charging my second battery right now. (I am not sure if its the 3DR brand spare I bought or the original battery, I didn't mark them right off the bat(t) haha not a bad pun) Also...

Thanks to you all, @Joe Horn and @Whirlygig WG did you end up finding a fix for the ALFA issue? I took my dremel and opened up the antenna wire input "hole," it is by NO means a Jack. I really don't know if it works, and all the reasearch I have seen points to there needing to be a specific...

(I know others have somewhat explained the solution further but I am just much better with seeing what's right vs some detailed descriptions) So everything that you and other said makes some sense. Is one of these two photos what you are all explaining, I.e. Which one is right or are they...

Look at my post below or watch the video....I have had two gimbals, and as long as it isn't "limp" "floppy" and responds to the controller (even if tilted), give this a shot....the code didn't work for me and I reaalllly reallly did the best calibration I could a few times. Thanks! and if...

I know I am new, but I tried the Terminal/Code calibration using my mac about 3 times and it still slopped aka tilted to the left where the black cylinder is......BUT THERE IS AN EASIER FIX THAN CODE! Just 1. TAKE THE GIMBAL OFF PARTWAYS 2.**MAKE SURE THE HDMI NOR GIMBAL CABLE ARE OBSTRUCTING...