Recent content by Fenti

Thanks, Michael. I haven't been following this issue. I just remember updating my GoPro previous and the streaming issue went away. I guess this was a while ago though when the app was still supported. I dug out an Android tablet and downloaded Solex--another work around ; )

Thanks @Pedals2Paddles. The reason I wanted to update is access to the ISO and the fact that the original software does not seem to play well with the gimbal--often loses live view.

Hi all, I just purchased a Peau 3.97 from a third party. I searched for GoPro settings and found the GoPro settings sticky, which was informative, but are there recommended settings for the 3.97 lens in particular, or tips for using this lens? Any links to more information would be appreciated...

Yeah, it's the right way up. There's a slight red mark on both connectors.

Just loosened the main board to get to the hdmi and removed 02 motorpod wires to make it easier. On reinstalling, I cannot get them to seat properly and don't want to force them (see photo). Is there a trick here? New to RC. Thanks.

Thanks for all the suggestions and links to helpful articles. I did get the feed going by removing and replacing the HDMI from both ends--who knows where it was not connected well, it seemed solid at both ends. I have tried everything I can to get rid of this without replacing cables and doing...

Thanks for the input, Maddog. Does the GPS upgrade in fact void the warranty? I read posts about guys sending their birds back with the mods in them to have them serviced. Or did I read this wrong. So I tried what @RichWest suggested and took out the battery tray to have a good look and...

Thanks. I don't know how I missed that thread reading about this. Maybe because there are many. No, I don't have it placed behind the post, but when I put it back together (without removing the battery tray) I can see the HDMI cable coming close to the isolation ball. I see how removing part of...

Thanks a lot for the info and advice, RichWest. You're right, there is less shake in reverse, but it's still there. When trying to figure this out, I noticed the HDMI cable seems short and when it loops around the front isolators, there isn't much room. I understand how viewing the cables from...

So I carefully checked and routed the cables and checked the isolation balls four times now and I can't fully get rid of this shake. Sometimes it's terrible, sometimes it's not that noticeable, but it's always there. I logged a ticket and if 3DR agree to replace this one I will be gimble-less...

No, I hadn't. Why shouldn't I do that? It looks like a good way to get that fat HDMI cable out of the way. Do you have advice as to how I should best route these cables? Is the only way I'm going to solve this problem going to be to buy the ribbon cable? I'm handy, but pretty new to working on...

Thanks, Pyrate. I did make sure the cables were not touching anything when I put it back together the first time but I will try it again as well as the level calibration. Too much wind here in NJ to fly today, but I'll report back. I just saw a video showing how to put the cable behind the...

Hey folks, I don't have more than three hours on my back up Solo (the first one is being repaired), and I just started trying to film with it. After reviewing my footage I noticed that in any slight wind, there is a pretty major vibration from the gimbal. I included a link to a Youtube video...

Thanks for trying to help out, Maddog. After some more troubleshooting with 3DR, they have determined the gimbal to be faulty and are going to send out a new one. I certainly hope this fixes the problem. Now to the issue with my backup Solo's gimbal vibrations. About to write another post asking...

Yes, Greg. If you follow the link it will take you to the FB page. No idea why it comes up with Chinese characters.