Recent content by divsrfsh

Hello, Which camera do you have? Hero 3&4 (black or silver)? Did you check both ends of HDMI? You may have to open controller and remove and re-install micro sd card. There are youtube videos on this task.

I'm interested in the remaining parts.

Actually, yes. But I have a whole new set of problems which still has me grounded. The new problems are on another thread. Going out of town again for a couple weeks.

Open Solo is a different platform. It will not give you a Solo update but will change the software installed. You should fix this problem before trying to upgrade to OpenSolo. I would 'forget' (erase) the old wi-fi address from the list in your network settings on your device. A Solo firmware...

It seems like a wi-fi issue. When I tried to connect different devices without re-starting everything I would get this message. You can go into your device, the one running Solex, and forget the Solo wi-fi then restart everything. Find the Solo wi-fi signal and type in your password. Then try to...

I am unable to pair my copter and controller. I have tried several times and un-installed and re-installed 3dr app. It does not appear(Solo) with either solex or 3dr app. I have turned devices on/off several times. I had success in swapping wi-fi cards on controllers. I receive the signal...

I have installed the microsd card from my broken controller which had open solo installed. I now have wifi but Solex not finding copter.Sigh.....

Have you tried to factory reset? With power off, start by holding power and fly. If that does not work I found the following instructions under all green lights on copter: "You'll need to execute these instructions many times until it works; Unfortunately, it also could fail and prove the...

Thanks, the broken controller has a frozen white screen. I will try swapping cards.

Peeled off the glue and r/r microsd card . Same results. No wi-fi signal. Re-booted controller and copter twice. Going to call it a day. thanks for the advice.

Xevet, thank you for your quick reply. I understand what has happened. I still have the controller open. The main board has a solid red light and the wifi board has a solid green light. No orange light.

IrishmanPDX, tried your suggestion with bad results. The controller froze with updating display. After 30 minutes I pulled the battery and re-booted. Now, the controller has no Wi-fi signal. Not picking up any Solo wi-fi signal across three different devices. Controller says waiting for solo...

I'm a little confused, the stick is not active until the FLY button is held and the green bar loads. After that the motors should start. I had a problem with my controller in that the power and fly buttons would stick. It caused all sorts of issues, usually landing and shutting itself down. I...

For anyone following this thread I am still unable to load Open Solo on my new controller. The controller did say at one point it paired with the copter. Unfortunately, I did not get P2P instructions until after the controller did an update. I tried to SSH into controller using WinSCP and...

I apologize to USMC86 and you. You are correct I should be happy that anyone responds to my request.We are a small group trying to make the best of things. I don't believe I was clear in my request. I burned out my controller. I am trying to load Open Solo on a new one. I cannot find a video...