Recent content by Crewdawg56

  1. C

    Anyone want a Storm32 gimbal adapter cable?

    Yes please
  2. C

    HAKRC 3 axis gimbal help

    what gimbal are you using on your solo?
  3. C

    HAKRC 3 axis gimbal help

    Hello everyone, I just purchased an HAKRC gimbal which worked out of the box but was doing some funky vibration chatter. I went into the gui and tried to smooth it out but instead the gimbal just rolls on me. I did make a mistake and forgot to copy down the factory settings. My question is does...
  4. C

    Solo goes into spin after takeoff

    Thanks it was my yaw parameter was off so reset to zero and had it do all the calibrations and successful. Xetet who is on the forum helped me.
  5. C

    Solo goes into spin after takeoff

    OK l will see what she is telling me
  6. C

    Solo goes into spin after takeoff

    Yeah it's plugged in correctly and I tried to look at the logs but I can't get them to open
  7. C

    Solo goes into spin after takeoff

    Stock 3dr compass antenna with the smooth side to the outside
  8. C

    Solo goes into spin after takeoff

    It had a very fast error ekg or something like that but it cleared itself and went back to normal. Stock solo other than gps mod and I just changed the compass antenna
  9. C

    Solo goes into spin after takeoff

    So today I have experienced my solo just after takeoff just start spinning. Still does it after reboot and recalibration of compass and IMU
  10. C

    no, it does nothing. so i did just hook up the usb and noticed in the status at the bottom of...

    no, it does nothing. so i did just hook up the usb and noticed in the status at the bottom of the GUI that IMU 2 is ok but IMU 1 it says none
  11. C

    the nt module its supposed to be error free. the lights on both the nt mod and the controller...

    the nt module its supposed to be error free. the lights on both the nt mod and the controller blinks green red on start up
  12. C

    problem is that my motors for most part are not coming alive

    problem is that my motors for most part are not coming alive
  13. C

    the CAM IMU is not the I2C IMU that we had or have. supposed to be better and error free. not...

    the CAM IMU is not the I2C IMU that we had or have. supposed to be better and error free. not getting the issue i was having before. however the board itself is much different and it does not have that 222 resistor that we usually have to jumper to get the motors to come alive
  14. C

    hey bud quick question. i changed my board of the gimbal to a storm32 NT hoping to help my...

    hey bud quick question. i changed my board of the gimbal to a storm32 NT hoping to help my situation do you know of any one on the forums that could lend me some knowledge or even you by any chance?
  15. C

    Enjoy!

    Awesome
See more