Recent content by Corvus Monitoring

Hello, Did you managed to make it work? I'm still stucked since the day I received it! (from Yarr actually, no problem dude, it's a long way project ;) ) My second option is to try to connect the servos directly to the autopilot, or another gimbal PCB card, to make it work independantly...

Thank you!! It worked! Julien

Ok, sorry, I've been a bit too simplist in my quote... I already spent hours and hours of testing / set up / try new things / restart from the beginning / change hardware etc. for solving problems somebody had already solved. This is the purpose for that kind of forum no?

Hello, I looked for an answer to my problem on the forum, but could'nt find it... I upgraded all my solo's to opensolo 4.0, with variou methods (solex/winscp...). I connect one of them to mission planner, it worked on the first time, as usual, but after that, no way to connect it again, I...

I'm just trying to make this gimbal work. Maybe I was not clear enough, I plugged the GH 1.25 connector on a standard rx, with a standard PWM signal, and the servo stay quiet... Standard servos on the same pins works properly, of course...

I wanted to do this, but I can't manage to get the servo working, even with direct connection. Maybe there is kind of interface between the connector and the servo... To be investigated! ;)

Hello, I don't have many time to spend with it as you can see, but I'm so disappointed to fail on it... I tried again to connect the servos directly by the GH 1.25mm, nothing moved. It's like the servo need a specific signal to work properly @Pedals2Paddles: do you know who could give...

So, After disassembling the cover of the servos, I discovered 2 MKS servos inside. I connected the pins to test them, at 5V, but nothing moved. I think there are HV servos that need at least 6V, maximum 8.2V. Do you think I could find these voltages in the Solo? Thank you!

Hello, After a few months of work without time to deal with that gimbal, I come back to try again to make it work. So what I understood is that I will not be able to use it as the originl sitescan solo (video feed, trigger etc.), and the gimbal is not compatible with latest firmwares. If someone...

I think my pack has a low cell, because it did not keep the charge. After a quick charge on the main connection to put it at 14v, I plugged it back on the solo charger and it worked properly. So... Why the BMS did not manage the discharge to balanced until 12V? I spent 50$ for a new lipo...

i tried solo charger, and Classic hobby charger (isdt)

Hello, I have 10 packs to mod, and began this week end with 5200mah packs from HK. I'm just stuck after the discharge step, as none of my chargers wants to charge the pack. The led blink 1 time slowly, then blink fast, and the battery cutoff... And unfortynately, the screen of my madhacker...

I have no instruction, only thought I had to replace the files in the root, setting the .param and reboot the solo. But you're right, it doesn't work... I have a gimbal_firmware 1.3.6 and a qbert_firmware 1.3.4, should I try to put them in the firmware folder before reboot?

Just foget about the "test OK boussole venture" file, it's something that has been tided at the wrong place ;)