Recent content by bclay1297

What is the difference between the ones that Ardupilot supports and the standalone modules?

Is there any built-in support for DroneID either in the Solo itself or in Ardupilot?

Do the factory reset again and start over. As long as the solo and controller will connect to each other to establish a WIFI it works with Solex. Make sure you catch the step to pair the solo and controller. I missed that and had to start over. Be patient. After you load the firmware on to...

I acquired a new solo with a lost password. I stepped through the procedure to reset the solo. I have paired the solo and controller and I see them in solex. It appears to be a black cube solo. I am trying to load OpenSolo 4.0.0 Clean Install on both the solo and the controller but both say...

45385 Do you know what color the cube is? It is visible from the gimbal bay

I am interested. Any idea how much it weighs? Trying to figure out how much shipping would be to Ohio

I cannot tell from this thread - are the drones still available?

Is it still available? Does it have OpenSolo or stock firmware? If OpenSolo what version?

Still available?? shipping from what state?

I found out that Solex receives a video stream from the Solo without any extra hardware. We should be able to see that on a PC with VLC if we knew the stream address. does anyone know what that might be?

I have a 3DR Solo with OpenSolo 4.0 loaded. I can get video from my Gopro on the HDMI port but I do not see any streaming in Wireshark. Can it be done with existing equipment? Can mavlink be used to control the video feed and gimbal?