Pixhawk from Solo and ProfiCNC carier board

pater · May 25, 2017

Hi all,

Is it possible to use pixhawk 2.0 from Solo with carier board from ProfiCNC which is dedicated for Pixhawk 2.1 ? And is it possible to run master on Pixhawk 2.0 with custom build (just only Pixhawk from Solo without ESC) ?

andrew.baker.142 · May 25, 2017

Wonderful question! I'm very interested in this as well. @Pedals2Paddles any thoughts?

Pedals2Paddles · May 25, 2017

You can put a Solo's pixhawk 2 cube in a ProfiCNC carrier. And you can run Master on the Pixhawk 2 cube. Just do not run master on a pixhawk 2 cube in a solo with the sock ESCs.